SNMP Configuration and Management Manual

Ethernet Subagent
SNMP Configuration and Management Manual—424777-006
14-52
3008: ZESA-EVT-EMSCOLL-UNAVAIL
ZEMS-VAL-reason
indicates the reason the interface with the EMS collector process has become
unavailable. The DDL AS clause associated with this value is inserted in the
message text following “cause.”
ZESA-VAL-STATE-state
Indicates the previous state of the interface with the EMS collector process. The
DDL AS clause associated with this value is inserted in the message text following
“previous state.”
ZESA-VAL-STATE-DISCONNECTED
indicates the current state of the interface with the EMS collector process. The
DDL AS clause of this value (“disconnected,” described above) appears in the
message text following “current state.”
zesaEmsCollectorName
is the name of the underlying process whose failure caused the interface between
the Ethernet Subagent and the EMS collector to go out of service. The name of the
EMS collector process specified for the subagent’s private zesaEmsCollectorName
MIB object is inserted in the message text following “underlying object.”
Value of
ZEMS-TKN-CHANGE-REASON
Associated Text (DDL AS Clause) and
Meaning
ZEMS-VAL-UNDERLYING-FAILED “underlying-serv-failed” indicates that an
underlying service on which the interface with
the EMS collector process depends has
failed.
ZEMS-VAL-OPERATOR-INITIATED “operator-initiated” indicates that an operator
has taken the EMS collector process out of
service.
Value of
ZEMS-TKN-STATE-PREVIOUS Associated Text (DDL AS Clause)
ZESA-VAL-STATE-CONNECTED “connected” indicates a normal operational
state.
ZESA-VAL-STATE-DISCONNECTED “disconnected” indicates a nonoperational
state where subagent function dependent on
the interface is not available.
ZESA-VAL-STATE-ENABLED “enabled” indicates that the interface has
been set by an operator such that the
subagent immediately attempts to restore it to
a connected state.
ZESA-VAL-STATE-DISABLED “disabled” indicates that the interface has
been taken out of service explicitly by an
operator setting the zesaEmsCollectorState
MIB object to “disabled.”