SNMP Configuration and Management Manual

SCF Error Messages for the NonStop Agent
SNMP Configuration and Management Manual—424777-006
B-3
SCF Error Messages Help
SCF Error Messages Help
To request help for any SCF error message:
-> HELP subsystem error-number
For example, suppose the following messages appears on your terminal:
SNMP E00001 Attribute conflict: HOSTADDR
SNMP E-00015 Object $ZSMP.#END1 Already Defined
SCF E20211 Invalid object type
To display additional information:
-> HELP SNMP 1
-> HELP SNMP -15
-> HELP SCF 20211
If You Have to Call HP
If the recovery for an error message indicates you should contact your service provider,
be prepared to supply the following information. (If the error caused SCF to terminate,
reenter SCF.)
1. Enter a LOG command to collect the following displays into a single file, for
example:
-> LOG PROBLEM !
2. Enter a LISTPM command to collect information about the product versions of the
SCF components, a list of the product modules on your system, and information
about any product modules running when the error occurred:
-> LISTPM
3. Enter an ENV command to collect information about the SCF environment that was
present when the error occurred:
-> ENV
If the error caused SCF to terminate, respecify any environmental characteristics
that were present when the error occurred.
4. Enter a DETAIL CMDBUFFER command to capture the contents of the SPI buffer:
-> DETAIL CMDBUFFER, ON
5. Reproduce the sequence of commands that produced the SCF error.