SNMP Configuration and Management Manual

Installing and Configuring the SNMP Agent
SNMP Configuration and Management Manual—424777-006
2-24
Stopping the SNMP Agent
See the TCP/IPv6 Configuration and Management Manual for information
about how to find the name of a TCP6SAM process.
See also The TCP/IP Subagent and Its Managed Resources on page 8-4.
The following example starts two SNMP agents on the same HP node. For Parallel
Library TCP/IP and NonStop TCP/IPv6, the TCP/IP process name is the
TCPSAM/TCP6SAM name.
$SYSTEM TCON 5> RUN $SYSTEM.SYSTEM.SNMPAGT/NAME $ZSNM0, NOWAIT/
$SYSTEM TCON 6> VOLUME $SYSTEM.TCON1
$SYSTEM TCON1 7> RUN $SYSTEM.SYSTEM.SNMPAGT/NAME $ZSNM1, NOWAIT/&
$SYSTEM TCON1 7> TCPIP^PROCESS^NAME $ZTC1
$SYSTEM TCON1 12> SCF
SCF - T9082D20 - (01JUN93) (18MAY93) - 01/09/96 12:38:06 System \EAST
Copyright Tandem Computers Incorporated 1986 - 1996
1-> INFO PROCESS $ZSNM0, SUB ALL
SNMP Info PROCESS
Name *EMS Collector
$ZSNM0 \EAST.$0
SNMP Info PROFILE
Name *Access *Hostaddr *Community
$ZSNM0.#DEFAULT READONLY 0.0.0.0 public
SNMP Info ENDPOINT
Name *Network *Hostaddr
$ZSNM0.#DEFAULT \EAST.$ZTC0 0.0.0.0
2-> INFO PROCESS $ZSNM1, SUB ALL
SNMP Info PROCESS
Name *EMS Collector
$ZSNM1 \EAST.$0
SNMP Info PROFILE
Name *Access *Hostaddr *Community
$ZSNM1.#DEFAULT READONLY 0.0.0.0 public
SNMP Info ENDPOINT
Name *Network *Hostaddr
$ZSNM1.#DEFAULT \EAST.$ZTC1 0.0.0.0
Stopping the SNMP Agent
To stop an SNMP agent process, issue the STOP command from a TACL prompt,
naming the agent process you want to stop:
STOP $ZSNMP