SPI Common Extensions Manual

ZCOM Errors
SPI Common Extensions Manual—427508-001
A-8
–5 ZCOM-ERR-CMD-NOT-SUPP (error)
subsys-type-name
represents any number of subsystem-defined tokens described in the subsystem-
specific management programming manual.
Cause. The command cannot be applied to objects of the specified type.
Effect. The command is rejected.
Recovery. For valid command/object-type combinations, see the subsystem-specific
management programming manual.
–5 ZCOM-ERR-CMD-NOT-SUPP (error)
The request specifies an invalid, unknown, or unsupported command.
ZCOM-TKN-OBJNAME
contains the name of the object specified in the request and is included if relevant
to the analysis of the error condition.
ZCOM-TKN-OBJTYPE
contains the object type (ZCOM-OBJ-objtype) specified in the request and is
included if relevant to the analysis of the error condition.
subsys-type-name
represents any number of subsystem-defined tokens described in the subsystem-
specific management programming manual.
Cause. A command was issued to a subsystem that does not support that command.
Effect. The command is rejected.
Recovery. For a list of supported commands, see the subsystem-specific
management programming manual.
–6 ZCOM-ERR-CMD-SEQ-INV (warning)
The command sequence is invalid. The command cannot be executed because of the
current activity or state of the target object. No consideration is given to the object’s
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR
ZCOM-TKN-OBJNAME token-type ZSPI-TYP-STRING
ZCOM-TKN-OBJTYPE token-type ZSPI-TYP-ENUM
subsys-type-name token-type subsys-defined
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL