SPI Common Extensions Manual

ZCOM Errors
SPI Common Extensions Manual—427508-001
A-37
–43 ZCOM-ERR-BKUP-NOT-RDY (error)
ZCOM-TKN-OBJNAME
contains the name of the object being processed and is included if relevant to the
analysis of the error condition.
ZCOM-TKN-OBJTYPE
contains the type (ZCOM-OBJ-objtype) of the object being processed and is
included if relevant to the analysis of the error condition.
subsys-type-name
represents any number of subsystem-defined tokens described in the subsystem-
specific management programming manual.
Cause. A hardware failure, configuration problem, or other difficulty occurred.
Effect. The command is not applied to the object.
Recovery. Reissue the command, specifying an available resource.
–43 ZCOM-ERR-BKUP-NOT-RDY (error)
The backup resource specified in a SWITCH command has not completed initialization
and is not ready to take over processing.
ZCOM-TKN-OBJNAME
contains the name of the object that was to be switched and is always included in
the error list for this error.
ZCOM-TKN-OBJTYPE
specifies the type (ZCOM-OBJ-objtype) of the object that was to be switched and
is always included in the error list for this error.
subsys-type-name
represents any number of subsystem-defined tokens described in the subsystem-
specific management programming manual.
Cause. The backup resource is not ready.
Effect. The switch does not take place.
Recovery. Verify that the backup resource is starting, wait until it is started, and
reissue the SWITCH command.
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR
ZCOM-TKN-OBJNAME token-type ZSPI-TYP-STRING
ZCOM-TKN-OBJTYPE token-type ZSPI-TYP-ENUM
subsys-type-name token-type subsys-defined
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL