SPI Common Extensions Manual

ZCDG Definitions
SPI Common Extensions Manual—427508-001
C-17
ZCDG Events
Z-TIME
contains the timestamp of the file from which the controller was updated.
ZCDG Events
Subsystems that deal with communications controller hardware might encounter the
events described in this section. The common event messages defined by ZCDG are
listed in Table C-1 and Table C-2 on page C-18. They can appear in either event or
Compaq Tandem Maintenance and Diagnostic System (TMDS) logs.
Table C-1. ZCDG Event Messages, by Number
Number Event Description
–10001 ZCDG-EVT-TAKEOWN-EIO Take ownership EIO instruction
issued.
–10002 ZCDG-EVT-RESET-EIO Reset instruction issued to
controller.
–10003 ZCDG-EVT-PON-INTRPT A controller has been powered on.
–10004 ZCDG-EVT-INTRPT-TIMEOUT No controller response to EIO
instruction.
–10005 ZCDG-EVT-INTRPT-UNEXP IOP detected unexpected
interrupt.
–10006 ZCDG-EVT-CTLR-DWLOAD IOP downloaded microcode to
controller.
–10007 ZCDG-EVT-SET-CONFIG Set port configuration.
–10008 ZCDG-EVT-LOAD-VFU Load printer VFU.
–10009 ZCDG-EVT-FUNC-ERR MFC function command error.
–10010 ZCDG-EVT-SET-FRAME-SIZE Load frame size EIO.
–10011 ZCDG-EVT-XFER-ABORT Data transfer aborted.
–10012 ZCDG-EVT-MFC-UNOWNED-EIO MFC unowned EIO.
–10013 ZCDG-EVT-MFC-HW-ERR MFC hardware error.
–10014 ZCDG-EVT-MFC-SW-ERR MFC software error.
–10015 ZCDG-EVT-MFC-MODEM-STATUS MFC modem status.
–10016 ZCDG-EVT-MFC-RECV-FRAME-OVRUN MFC receive frame overrun.
–10017 ZCDG-EVT-NO-CTLR-BUF MFC no controller buffer.
–10018 ZCDG-EVT-DIAG-TEST Diagnostic test executed.
–10019 ZCDG-EVT-DIAG-UPDATE Controller software SEEROM
updated.
–10020 ZCDG-EVT-DIAG-ERR Diagnostic error occurred.
–10021 ZCDG-EVT-CLIP-PROBE-ERR CLIP probe error.
–10022 ZCDG-EVT-CIU-ERR CIU error detected.