SPI Common Extensions Manual

ZCDG Definitions
SPI Common Extensions Manual—427508-001
C-26
–10007 ZCDG-EVT-SET-CONFIG
ZEMS-TKN-ZFILERR
contains the error number of any file error encountered by the downloading
process while accessing the microcode file.
ZCDG-TKN-DWLOADID
contains the identification of the downloading software.
Cause. The controller has been replaced and powered up, or the controller has been
reset following a failure.
Effect. If the event contains no error information, the controller now contains a fresh
copy of its microcode.
Recovery. If the event contains an error number, it indicates the cause of the failure.
Verify that the microcode file is present and properly secured. Check the versions of
the microcode and the downloading process.
–10007 ZCDG-EVT-SET-CONFIG
The configuration of the indicated device has been changed.
ZEMS-TKN-EVENTNUMBER
has the value ZCDG-EVT-SET-CONFIG.
Cause. The configuration of the specified device has been changed, and this event
reports the new configuration.
Effect. The device is operating under the indicated configuration.
Recovery. No recovery is necessary. The information in this event might be needed to
interpret other event messages describing the same device.
Tokens in Event Message
ZEMS-TKN-EVENTNUMBER token-type ZSPI-TYP-ENUM
ZEMS-TKN-SUBJECT-MARK token-type ZSPI-TYP-MARK
ZCOM-TKN-SUBJ-objtype token-type ZSPI-TYP-STRING
ZEMS-TKN-LDEVNAME <2> token-type ZSPI-TYP-FNAME32
Message Text
MFC Async port #<1> configuration set. Device :<2>
BAUD: PARITY: DUPLEX: BREAK:
MODE: AUTOLF: CHARSZ: STOPB:
INTF: AUTODIS: CFLFDEL: VTDEL: