SPI Common Extensions Manual

ZCOM Data Definitions
SPI Common Extensions Manual—427508-001
4-4
ZCOM Tokens
ZCOM-TKN-CMD-TIMEOUT
Include this token in a command to specify the number of microseconds an SCP
process waits for a response from the subsystem to which SCP forwarded the
command. If this time is exceeded, the command is canceled if it has not completed.
ZCOM-TKN-CPU-SWITCH-CAUSE
CPU-SWITCH event messages include this token to specify the reason for the switch.
Valid values and the reasons they represent are:
ZCOM-TKN-DIAG-OPT
Include this token in a DIAGNOSE command to specify whether an object should enter
or terminate from a DIAGNOSING state. Valid values are:
token-code ZCOM-TKN-CMD-TIMEOUT
value ZCOM-TNM-CMD-TIMEOUT
token-type ZSPI-TYP-TIMESTAMP
ssid "TANDEM.21.0"
heading "Timeout".
token-code ZCOM-TKN-CPU-SWITCH-CAUSE
value ZCOM-TNM-CPU-SWITCH-CAUSE
token-type ZSPI-TYP-ENUM
ssid "TANDEM.21.0"
heading "CPU-switch-cause".
ZCOM-VAL-HW Hardware failure
ZCOM-VAL-OP-REQ Operator-initiated command
ZCOM-VAL-PROTO Protocol
ZCOM-VAL-TKOVR Backup takeover
ZCOM-VAL-UNKNW Cause unknown
token-code ZCOM-TKN-DIAG-OPT
value ZCOM-TNM-DIAG-OPT
token-type ZSPI-TYP-ENUM
ssid "TANDEM.21.0"
heading "Diagnose-option".
ZCOM-VAL-DIAG-OPT-ENTER Specifies to enter the DIAGNOSING state
ZCOM-VAL-DIAG-OPT-EXIT Specifies to exit the DIAGNOSING state