Spooler Plus Programmer's Guide

Spooler-Related Errors
Spooler Plus Programmer’s Guide—522293-003
C-2
Interface Errors
Recovery. Refer to the information on file-system errors in the Guardian Procedure
Errors and Messages Manual for corrective action for the error number indicated in bits
<8:15>.
Cause. A parameter is missing.
Effect. The spooler ignores the request.
Recovery. Correct the syntax and reenter the command.
Cause. The content of a parameter is wrong, or both filenum and filenum-to-
collector were specified (only one can be specified).
Effect. The spooler ignores the request.
Recovery. Correct the syntax and reenter the command.
Cause. The format of a spooler job file (file code 129) is invalid. A job from a previous
session is not correctly formatted.
Effect. The spooler ignores the request.
Recovery. Purge the spooler job file and build a new one.
Cause. A checkpoint exit occurred. This error code has special significance for an
application running as a NonStop process pair. If bit 11 of the flags parameter of
SPOOLSTART was set to 1, the procedures SPOOLWRITE, SPOOLCONTROL,
SPOOLCONTROLBUF, and SPOOLSETMODE return a value of %11000 when the
level-3 buffer is about to be written to the collector.
Effect. The block is complete and ready to be written to the data file.
Recovery. Checkpoint the buffer and repeat the call.
Cause. A process attempted to write to the collector without first opening the file. This
error occurs if the collector was not opened successfully.
4096 (%10000)
4097 (%10001)
4098 (%10002)
4608 (%11000)
4609 (%11001)