Spooler Plus Programmer's Guide

Spooler-Related Errors
Spooler Plus Programmer’s Guide—522293-003
C-10
Print Procedure Errors
Effect. The operation is ignored.
Recovery. Perform the operation on the spooler batch job, or unlink the spooler job
from the spooler batch job and retry the operation.
Cause. An attempt was made to link a spooler job whose attributes (owner, form,
device, and gmom-crtpid-jobid) do not match those of the spooler batch job.
Effect. The operation is ignored.
Recovery. Change the key attributes of the spooler job to match those of the spooler
batch job.
Cause. An attempt was made to link a spooler job to a spooler batch job, but the
spooler job already belonged to the spooler batch job.
Effect. The operation is ignored.
Recovery. None.
Cause. There was an attempt to unlink a spooler job from a spooler batch job
although they were not linked.
Effect. The operation is ignored.
Recovery. This is an informative message only; no action is needed.
Cause. An error occurred while the system was creating a collector or print process.
Effect. The spooler ignores your request.
Recovery. Refer to the information about the PROCESS_CREATE_ errors Guardian
Procedure Errors and Messages Manual for corrective action concerning error
information returned in the error-detail parameter.
Print Procedure Errors
Consider the following when you handle codes returned by print procedures:
6161 (%14021)
6162 (%14022)
6163 (%14023)
32768-36771 (%100000 - %107477)