Spooler Plus Programmer's Guide

Using the Spooler Interface Procedures

Spooler Plus Programmer’s Guide—522293-003

2-20

Spooling—Levels 1 and 2

line [0:39],

! contains the line of data to spool

length;

! contains the number of bytes to write from line

! Start the backup and check if this is the backup

CALL stbackup;

! Open file to collector, and check for errors.

CALL OPEN( collector, collectnum, flags, 0);

IF <> THEN CALL error;

! CHECKOPEN the successful open to the collector

! and test for error.

CALL CHECKOPEN( collector, collectnum, flags,0,,, err);

IF <> THEN CALL cherror(err);

! Get a line of data and test for done.

! If done, fall through.

WHILE getline(line, length) DO

BEGIN

! CHECKPOINT stack (including line of data) and

! synchronization block

err := CHECKPOINT(line, , collectnum);

! Write the line to the collector and check for errors

CALL WRITE ( collectnum, line, length);

IF <> THEN CALL error;

END;

! Close the file to the collector

CALL CLOSE(collectnum);

IF <> THEN CALL error;

! Stop backup and stop primary

CALL cherror(0);

CALL STOP;

END;

Example 2-5. Annotated Example of Level-1 Spooling From a NonStop Process

Pair With a Zero Sync Depth

(page3of3)