Spooler Plus Utilities Reference Manual

Spoolcom
Spooler Plus Utilities Reference Manual—522294-002
3-22
DEV Command
NONE specifies that no multibyte character-set translation is required. This is
the default value if the CHARMAP subcommand is not used or is used without
a parameter.
IBMKANJIKANA specifies the IBM Kanji character set.
JEFKANJIKANA specifies the Fujitsu Kanji character set.
JISKANJIKANA specifies the JIS C-6234 or C-6220 character set.
CLEAR [ DEL ]
stops printing the current job. If DEL is specified, the job is deleted from the
spooler subsystem; otherwise, the DEV command returns the job to the end of
the device queue. The device remains online so the next job in the device print
queue can begin printing.
DELETE
removes the device from the spooler subsystem. This subcommand works
only if the device is not connected to any location (that is, it has been
disconnected by the LOC DEV command or removed with the LOC DELETE
command) and has no jobs in its queue (that is, it has been drained using the
DEV DRAIN command).
DEVRESET [ ON | OFF ]
specifies whether the spooler print process resets both the print device and the
print input/output process (IOP) at the beginning of each print job. This
subcommand is supported only by FASTP and the Universal Interface (UI) IOP
(parallel print process).
If DEVRESET is not specified, it defaults to OFF. If DEVRESET or
DEVRESET ON is specified, it causes the spooler print process to reset the
print IOP and the print device to its configured default values at the beginning
of each print job.
DEVRESET OFF causes the spooler print process to reset the print IOP, but
not the print device, to its configured default values at the beginning of each
print job. See Considerations on page 3-34 for exceptions.
DEVTYPE [ blank | LU1 | LU3 | 7 | 8 | 9 | 10 |
5512 | 5515 | 5516 | 5518 | 5573 | 5574 | 5577 ]
The default value is blank.
This parameter is required only when the IOP to which the device is attached
cannot determine the device type (a DEVICE INFO command does not return
a device type). A connection to a LAN printer is an example of a situation
where the DEVTYPE parameter is required.
DEVTYPE blank sets the print device configuration to blank.