Spooler Plus Utilities Reference Manual

Spoolcom
Spooler Plus Utilities Reference Manual—522294-002
3-27
DEV Command
•
The FASTP print process uses parameter as follows:
<0:8> Reserved. Set to 0.
<9>
<9>
= 0 Print headers in the normal orientation, which is portrait.
For 5577 printers, you should disable offset of jobs on
output.
= 1 For jobs sent to 5573, 5574, and 5577 printers, set 10-
point, 12-cpi landscape text for header and trailer pages.
For 5577 printers, issue a PCL job-separation command
before printing the job (which causes each job to be offset
in the output bin).
<10>
<10>
= 0 For jobs transferred to a target spooler collector, retain the
same job ownership at the target spooler as at the source
spooler.
= 1 For jobs transferred to a target spooler collector, set job
ownership at the target node to the print process
(PROCESSACCESSID) performing the transfer.
<11>
<11>
= 0 For jobs transferred to a target spooler collector, set the
HOLDAFTER flag as indicated in bit <12>. This bit is
ignored for jobs sent to devices other than spooler
collectors.
= 1 For jobs transferred to a target spooler collector, always
set the HOLDAFTER ON flag. This bit is ignored for jobs
sent to devices other than spooler collectors.
<12>
<12>
= 0 For jobs transferred to a target spooler collector, always
set HOLDAFTER OFF. This bit is used only if bit
<11> = 0. This bit is ignored for jobs sent to devices other
than spooler collectors.
= 1 For jobs transferred to a target spooler collector, always
retain any HOLDAFTER value specified for the job at the
source spooler when transferred to the target spooler.
This bit is used only if bit <11> = 0. This bit is ignored for
jobs sent to devices other than spooler collectors.
<13>
<13>
= 0 Set target location name to that of the source job location.
= 1 Set target location name to that of the device thread
name.