Spooler Plus Utilities Reference Manual

Spoolcom
Spooler Plus Utilities Reference Manual—522294-002
3-38
DEV Command
LAST ERROR is the octal number of the last error printed on the error log file. The
%004016 error shown here is translated by reading bits 8 through 15. Bits 8
through 15 contain 00 001 110, which translates to 016 octal or 14 decimal: an
error that is typically caused by a device not existing in the system.
3. If the job currently printing is yours, you can use the SKIPTO subcommand to skip
ahead in your spooled program to a page number (found by using Peruse).
4. The SKIP subcommand enables you to skip ahead or back a specified number of
pages in your program printing. For instance, if the ribbon turned or the paper
became mangled, this command allows you to make the printer go back and
reprint the last eight pages to produce a clean copy:
5. If $HT1 has gone offline because it ran out of paper, you can restart it (after putting
in new paper) with this command:
STATE: OFF LINE
LAST ERROR: %004016
EXCLUSIVE: OFF
FIFO: OFF
HEADER: ON
TRUNCATION: OFF
DRAINING: NO
PRINTING JOB: NONE
PARM: 0
PROCESS: $PR10
RETRY: 5
TIMEOUT: 360
SPEED: 100
WIDTH: 132
FORM:
RESTART: OFF
DEVRESET: OFF
DEVTYPE:
STARTFF: OFF
ENDFF: OFF
CHARMAP: NONE
PREXLATE: OFF
LUTOFVALUE: CRFFCR
LUEOLVALUE: CRLF
LUEOLWHEN: LT132
)
)DEV $DUZ1, SKIPTO 43
)DEV $LP3, SKIP -8
)DEV $HT1, START