Spooler Plus Utilities Reference Manual

Spoolcom
Spooler Plus Utilities Reference Manual—522294-002
3-39
DEV Command
Examples for Authorized Users
1. In the example below, the print process that is to control device $LP3 is specified
and causes all jobs printed on that device to have a header page:
2. The START subcommand is used to bring back online a device that has been
taken offline for any reason:
3. The printer $LP1 is deleted from a running spooler subsystem by first draining the
device and then disconnecting it from its location:
4. In this example, device $LP3 is currently printing job 10; and jobs 20, 30, 40, and
50 are in the device queue.
To make job 40 the next job to print, you can enter the following:
5. A typical configuration for a laser printer, type 5577, to use the FASTP print
process is shown in Table 3-10 as reported by a detailed DEV STATUS command.
The DEV commands to configure this printer are shown following the status listing.
)DEV $LP3, PROCESS $XP, HEADER ON
)DEV $LP3, START
)DEV $LP1, DRAIN
)LOC #LP1.LP1, DEV
)DEV $LP1, DELETE
)DEV $LP3
DEVICE STATE FLAGS PROC FORM«$LP3 JOB
10 H $SPLP
JOB LOCATION DEVICE SEQ COPY PAGE
10 #LP3.DEFAULT $LP3 PRINT 1 10
20 #LP3.DEFAULT $LP3 2 1 10
30 #LP3.DEFAULT $LP3 3 1 10
40 #LP3.DEFAULT $LP3 4 1 10
50 #LP3.DEFAULT $LP3 5 1 10
)DEV $LP3,JOB 40; DEV $LP3
DEVICE STATE FLAGS PROC FORM
$LP3 JOB 10 H $SPLP
JOB LOCATION DEVICE SEQ COPY PAGE
10 #LP3.DEFAULT $LP3 PRINT 1 10
40 #LP3.DEFAULT $LP3 2 1 10
20 #LP3.DEFAULT $LP3 3 1 10
30 #LP3.DEFAULT $LP3 4 1 10
50 #LP3.DEFAULT $LP3 5 1 10