Spooler Plus Utilities Reference Manual

Spoolcom
Spooler Plus Utilities Reference Manual—522294-002
3-40
DEV Command
The following DEV commands implement the configuration shown in Table 3-10:
DEV $LZ5577.#A, DEVTYPE 10, PARM 64, PROCESS $SPLX
DEV $LZ5577.#A, SPEED 900, RESTART 300, DEVRESET ON, ENDFF ON
Table 3-10. Typical Configuration for Laser Printer Type 5577
Device Attribute Default? Description
EXCLUSIVE: OFF Yes Close the device when no jobs are waiting.
FIFO: OFF Yes Use the queuing algorithm that considers the
relative job length and the time jobs have been
queued.
HEADER: ON Yes Print the banner at the beginning of every job.
TRUNCATION: OFF Yes Print wrapped text on the next line.
PARM: 64 (%100) No Use landscape headers.
PROCESS: $SPLX No Use the FASTP print process. $SPLX is
suggested for the FASTP process name. There
is no default value for the PROCESS
subcommand, but the specified name must have
been associated with FASTP through a
previously issued PRINT command.
RETRY: 5 Yes Wait 5 seconds before retrying a failed retryable
operation to the device.
TIMEOUT: 360 Yes Retry a failed retryable operation to the device
360 times.
SPEED: 900 No Use this speed for estimating print time.
WIDTH: -1 Yes Use the record size obtained by the file-system
DEVICEINFO procedure for the maximum line
length.
RESTART: 300 No Wait 300 seconds before a restart attempt.
DEVRESET: ON No Reconfigure the print IOP and the print device to
their default values at the beginning of each print
job.
DEVTYPE: 10 No Configure the device for a 5577 printer.
STARTFF: OFF Yes Suppress a form feed at beginning of job.
ENDFF: ON No Eject page at end of job.
CHARMAP: NONE Yes No multibyte character set is used.
PREXLATE: OFF Yes Perform no prespace-to-postspace translations.
LUTOFVALUE: CRFFCR Yes N/A
LUEOLVALUE: CRLF Yes N/A
LUEOLWHEN: LT132 Yes N/A