Spooler Plus Utilities Reference Manual

Spoolcom
Spooler Plus Utilities Reference Manual—522294-002
3-60
JOB Command
4. To get job summary information, use the following command:
5. To list the contents of a job, use the following command:
The following information is displayed:
6. In the following example, the JOB command is used to alter job attributes. The job
is placed in the hold state to make the changes, the hold-after-printing flag (A) is
set on, the report name for the header page is altered, and a status display is again
requested, followed by the START subcommand to remove the job from the hold
state:
The following information is displayed:
)JOB, SUMMARY
)JOB 3000, CURRENT
3000 JOB) LIST
JOB: 3000
STATE: READY
LOCATION: #LOC1
FORM:
REPORT: COMMSW RJ
HOLD BEFORE PRINT: NO
HOLD AFTER PRINT: NO
ABNORMAL: NO
SELECTION PRIORITY: 4
PAGE SIZE: 60
CREATOR ACCESS ID: 4, 19
COPIES: 1
PAGES: 3
TOTAL LINES: 169
OPEN TIME: 28 MAY 96, 10:23:00
CLOSE TIME: 28 MAY 96, 10:23:18
DATA FILE: $KIRK.TESTLIM.CD1
COLLECTED BY: $COL1
UNITS ALLOCATED: 2
BATCH ID:
BATCH NAME:
MAXIMUM LINES:
MAXIMUM PAGES:
)JOB 36, HOLD, HOLDAFTER, REPORT PB REPT,STATUS,START
JOB BATCH ST FLAGS OWNER TIME COPY PAGE REPORT LOCATION
36 HL 4 A 4,19 10:18 1 5 PB REPT #UNTIL