Spooler Plus Utilities Reference Manual

Spoolcom
Spooler Plus Utilities Reference Manual—522294-002
3-79
PRINT Command
When DETAIL is specified, the information in Table 3-17 is shown:
Examples for All Users
1. To display the status of a print process, enter
The following information is displayed:
2. To display the status of that same print process in greater detail, enter
Table 3-17. PRINT STATUS Display Entries (With DETAIL Option)
Entry Description
PRINT PROCESS Is the name of the print process whose status is being given.
STATE Is the same as that shown in Table 3-16 except when an error
has occurred. Then only the word ERROR is displayed and
the error number is displayed in LAST ERROR.
LAST ERROR Is the octal number of the last error printed on the error log file.
It can be %1000, %2000, %3000, %4000, or %5000 plus a
file-system error number, or %100000 plus a NEWPROCESS
error number. The octal error number is a 16-bit value where
bits 8 through 15 contain the file-system error number.
DEBUG Indicates that the process is in debug mode.
INDEPENDENT Indicates that the process is an independent process.
PROGRAM FILE Is the name of the print process program file.
CPU
BACKUP
Give the numbers of the processors that will run the primary
and backup processes.
PRIORITY Is the execution priority at which the print process runs.
PARM Is the print-process parameter.
)PRINT $SPLA
PRINT STATE FLAGS CPU PRI
$SPLA ACTIVE 5 , 9 145
)PRINT $SPLA , STATUS DETAIL