Spooler Plus Utilities Reference Manual

Spoolcom
Spooler Plus Utilities Reference Manual—522294-002
3-90
VOLUME Command
VOLUME Command
The VOLUME command changes the current default volume or subvolume names, or
both, used with Spoolcom. The initial default names are the subvolume and volume
names that were the current default names when you started Spoolcom.
\system
sets the current default system name for Spoolcom. You can set the default
system name only in a named system, such as one in a network.
$volume
sets the current default volume name for Spoolcom.
subvol
sets the current default subvolume name for Spoolcom.
Considerations
•
Entering VOLUME with no volume or subvolume name restores the default names
that were in effect when you started Spoolcom.
•
Spoolcom and the command interpreters have separate default names for system,
volume, and subvolume. When you return to the command-interpreter prompt
from Spoolcom, the default names are reset to the values that were in effect before
you started Spoolcom.
Examples
1. This command sets the current default subvolume name for Spoolcom to SUBVOL1
but does not change the current default volume or system:
)VOLUME SUBVOL1
2. This command sets the current default volume name for Spoolcom to $DEFVOL but
does not change the current default subvolume or system:
)VOLUME $DEFVOL
3. This command sets the current default system, volume, and subvolume names for
Spoolcom to \ITALY.$MILANO.ARTWORK:
)VOLUME \ITALY.$MILANO.ARTWORK
VOLUME [ [\system.]$volume.subvol ]
[ $volume ]
[ subvol ]