Spooler Plus Utilities Reference Manual

ManualsBrandsHP ManualsServerHP NonStop G-Series

191

192

193

194

195

196

197

198

199

200

Font Utility

Spooler Plus Utilities Reference Manual—522294-002

4-17

Script File Example

The following is an example of a script file. This file is input to the Font utility, which

loads font jobs in the spooling system. These font jobs are used by locations with

Laser-LX and other similar PCL devices attached. The script file also supplies

information to enable the configuration of these locations.

Initial text is comments.

?START-FONT ! Identifies the start of the FONT section

! that describes font jobs.

?FONT PORTRAIT ! An example PCL font

! Comments go here

?SETMODE 6 0 1 ! Transparent ON

%33,"E" ! Reset

%33,"&l0O" ! Portrait

%33,"&l6D" ! 6 lines per inch

%33,"&l1S" ! Duplex long-edge binding

%33,"(8U" ! Roman 8

%33,"(s12V" ! Point 12

%33,"(s10H" ! Pitch 10

?SETMODE 6 1 0 ! Transparent OFF

?CONTROL 1 0 ! Form feed

?FONT TRANSP ! Another example font job, this

! one enables transparent printing

?SETMODE 6 0 1 ! Transparent ON

?END-FONT ! Identifies the end of the section.

! This completes the FONT section.

?START-LOCATIONS ! Identifies the LOCATIONS section.

! Location entries describe

! locations to be added

! Note that the format of location entries is:

! <location> [,] <font-name> [,] <device>

#LX.PORT PORTRAIT $LASER.#A

#LX.GLASS TRANSP $LASER.#A

?END-LOCATIONS ! Identifies the end of LOCATIONS section.

Notice that the file has two sections: The first describes the font jobs to be created,

and the second details the locations.

A directive has a question mark (?) as the first nonblank character.

Text preceding the START-FONT directive is treated as a comment. Text to the right of