Spooler Plus Utilities Reference Manual

RPSetup Utility
Spooler Plus Utilities Reference Manual—522294-002
5-10
ASSIGN and PARAM Commands
ASSIGN and PARAM Commands
The syntax for the commands listed in Table 5-1 is described in the following
subsections.
ASSIGN PRINTFILE
The ASSIGN PRINTFILE command specifies the Guardian file name of the program
file for the print process controlling the interspooler thread. This configuration
parameter applies individually to all interspooler threads.
object-filename
is the object file name, in local format, of the print process. The default name is
$SYSTEM.SYSTEM.FASTP.
PARAM BUPCPU
The PARAM BUPCPU command configures the print process that controls the
interspooler threads. The command specifies the backup processor and is equivalent
to the Spoolcom command PRINT BACKUP.
backup-cpu
is an integer in the range 0 through 15 specifying the backup processor for the
print process that controls the interspooler threads. The default processor is the
backup processor for the local spooler supervisor.
PARAM PRINTPARM Sets parameters 0 PRINT PARM
PARAM PRIORITY Sets the priority of
the print process
that controls the
interspooler threads
Target supervisor priority
minus 10
PRINT PRI
PARAM THREADNAME Sets the generic
portion of the
device name for
interspooler threads
Default name of the first
active collector in IN
remote-spooler with
this qualifier:
#XFER.THREADnn
None
ASSIGN PRINTFILE , object-filename
PARAM BUPCPU backup-cpu
Table 5-1. ASSIGN and PARAM Command Default Values (page3of3)
RPSetup Parameter Description Default Value
Corresponding
SPOOLCOM
Command