Spooler Plus Utilities Reference Manual

RPSetup Utility
Spooler Plus Utilities Reference Manual—522294-002
5-13
ASSIGN and PARAM Commands
For more information on parameter values, see the DEV PARM command in Section 3,
Spoolcom.
PARAM DEVRESTART
The PARAM DEVRESTART command sets the interval the device waits between
automatic restart attempts. This configuration parameter applies individually to all
interspooler threads. The command is similar to the SPOOLCOM command
DEV RESTART.
interval
is the number of seconds the device waits between automatic restart attempts.
The value is in the range 10 through 32767 seconds. The default is 30 seconds.
PARAM DEVTRUNC
The PARAM DEVTRUNC command specifies whether lines longer than the device
width are to be truncated or wrapped around. This configuration parameter applies
Table 5-2. Default Attributes Set by FASTP on Interspooler Transferred Print
Jobs
Bit Value Attribute of Transferred Print Jobs FASTP’s Default Operation
< 10 > 0
Retains the same job ownership at the
target spooler as at the source spooler
Equals 0. For example, if user
ADMIN.OPERATOR submitted a job at
the source node, FASTP sets
ADMIN.OPERATOR as the job’s
owner at the target node.
1
Sets job ownership
(PROCESSACCESSID) at target node
to the print process performing the
transfer
< 11 > 0
Omits any HOLDAFTER flag for a job
transferred to target spooler
Equals 0. FASTP delivers all jobs
without a HOLDAFTER flag to the
target spooler.
1
Always sets the HOLDAFTER flag for a
job transferred to a target spooler
< 12 > 0 Omits any HOLDAFTER flag for a
job transferred to target spooler
Same as < 11 >.
1 Retains any HOLDAFTER flag for a
job transferred to a target spooler
< 13 > 0 Sets target location name to that of
the source job location
Equals 0. For example, a job sent
to location $S.#OFFICE.A has this
same location name after being
transferred to the target spooler.
1 Sets target location name to that of
the device thread name
PARAM DEVRESTART interval