Spooler Plus Utilities Reference Manual

SPOOL Program
Spooler Plus Utilities Reference Manual—522294-002
A-2
Running the SPOOL Program
The default priority is 1 less than the priority of the command interpreter from which
the supervisor is run.
CPU primary-cpu
is the processor number of the processor module (0 through 15) in which the
supervisor’s primary process runs.
The default processor module is the same processor module that the command
interpreter is located in.
backup-cpu
is the processor number of the processor module (0 through 15) in which the
supervisor’s backup process is to run.
If this parameter is omitted, the supervisor runs without a backup.
coldstart-parameters
are the parameters described below. The first five of these parameters are
required when the spooler is coldstarted.
You must also include the REBUILD option in order to increase any of the
parameters in a warm start. You cannot decrease any values of coldstart-
parameters without cold starting the spooler.
If you do not use the REBUILD option, coldstart-parameters cannot be
changed without cold starting the spooler again.
num-of-jobs
is the maximum number of jobs that the spooler will handle at any one time.
The range is 2 through 65534. There is no default.
num-of-locations
is the maximum number of destinations and groups the routing structure will
contain. For example, the number of locations for a routing structure
containing only the locations #DEFAULT.DEFAULT and #MYGRP.YRDEST must
be at least four: two locations plus two groups. The range is 2 through 32765.
There is no default.
num-of-devices
is the maximum number of devices that can be known to the spooler at any
one time. The range is 1 through 4095. There is no default.
num-of-collectors
is the maximum number of collectors that will ever be declared for this spooler.
The range is 1 through 31. There is no default.