Spooler Plus Utilities Reference Manual

Spooler Plus Utilities Reference Manual—522294-002
B-1
B Peruse Messages
This appendix describes the Peruse error messages that are displayed on your
terminal. For additional information on Peruse, see Section 2, Peruse.
Cause. A file-system error occurred during input/output (I/O) to a spooler data file.
Effect. Peruse cannot access the data file for this job.
Recovery. Refer to the Guardian Procedure Errors and Messages Manual for
corrective action for file-system error number.
Cause. A file-system error occurred during input/output (I/O) to a supervisor process.
Effect. The operation terminates.
Recovery. Check the status of the supervisor using the Spoolcom SPOOLER
command, or call the system operator. Also, refer to the Guardian Procedure Errors
and Messages Manual for corrective action for the file-system error number.
Cause. The OUT file of a LIST command was a nonexistent disk file. Peruse tried to
create the file and CREATE failed. number specifies the file-system error.
Effect. The operation terminates.
Recovery. Refer to the Guardian Procedure Errors and Messages Manual for
corrective action for file-system error number.
Cause. The Guardian OPEN procedure returned an error when Peruse tried to open
the OUT file.
Effect. Peruse does not open the OUT file.
Recovery. Refer to the Guardian Procedure Errors and Messages Manual for
corrective action for the file-system error number.
ACCESS TO SPOOL DATA FILE FAILED, FILE ERROR number
ACCESS TO SPOOL SUPERVISOR PROCESS FAILED, FILE ERROR number
CAN'T CREATE 'OUT' FILE: number
CAN'T OPEN 'OUT' FILE: number