Spooler Plus Utilities Reference Manual

Peruse Messages
Spooler Plus Utilities Reference Manual—522294-002
B-7
Cause. A DELETE command was given, but no current job was defined.
Effect. Peruse ignores your command.
Recovery. Peruse requires that you specify the current job before deleting it. Use the
JOB command to specify the current job, and then use the DELETE command to
delete it.
Cause. A command that refers to the default job was entered, but no job was found in
the spooler.
Effect. The spooler ignores the command.
Recovery. Respool the job, and then reenter your command.
Cause. A FIND command was entered without a string parameter, and no previous
FIND command with a string parameter had been entered.
Effect. The spooler ignores the command.
Recovery. Reenter the FIND command with a string parameter.
Cause. A LOC command was entered that specified a new spooler location, but the
spooler table for locations is already full.
Effect. The spooler ignores the command.
Recovery. Warmstart the spooler with more locations configured and specify the
REBUILD option to the SPOOL command. If you cannot warmstart the spooler, delete
any locations that are not used.
Cause. A JOB command was entered with a job number that didn’t match any of your
jobs in the spooler.
Effect. The spooler ignores the command.
Recovery. Check your job number, and then reenter the command.
NO CURRENT JOB
NO JOBS AVAILABLE
NO OLD FIND STRING TO USE FOR COMPARES
NO ROOM FOR ENTRY IN SPOOLER TABLES
NO SUCH JOB