Spooler Plus Utilities Reference Manual

Peruse Messages
Spooler Plus Utilities Reference Manual—522294-002
B-8
Cause. You attempted an operation on a job that is part of a batch job.
Effect. The operation is ignored.
Recovery. Either retry the operation on the batch job, or unlink the job from the batch
job and then retry the operation.
Cause. A Guardian OPEN procedure encountered a file-system error.
Effect. Peruse cannot open the spooler supervisor process specified in the command
to run Peruse or the Peruse OPEN command. (The spooler supervisor process is
$SPLS or a name given by supervisor.)
Recovery. Verify that you specified the correct spooler supervisor. If you did not,
reexecute your command. If you did, refer to the Guardian Procedure Errors and
Messages Manual for corrective action for the file-system error number.
If the error is file-system error 14, the spooler has no supervisor. Bring the system up
again.
If the error is file-system error 32 or 34, the supervisor has too many opens at one
time. Wait until some operations have finished, and then retry the operation.
Cause. EDIT was specified in a LIST command, and the OUT file was not an EDIT
file.
Effect. The command is not executed.
Recovery. Specify an EDIT file as the OUT file, and then retry the command.
Cause. SPOOL or COMPRESS was specified in a LIST command, and the OUT file
was not a process or a spooler job file.
Effect. The command is not executed.
Recovery. Specify a process or a spooler job file as the OUT file, and then retry the
command.
NOT ALLOWED ON PART OF A BATCH JOB
OPEN OF SPOOL SUPERVISOR FAILED, FILE ERROR: number
'OUT' FILE MUST BE EDIT FILE
'OUT' FILE MUST BE PROCESS OR SPOOLER JOB FILE