Spooler Plus Utilities Reference Manual

Peruse Messages
Spooler Plus Utilities Reference Manual—522294-002
B-10
Cause. The command you entered would change the attributes of a current job, but
your job is already in the print state.
Effect. The spooler ignores your command.
Recovery. To execute your command, put the job on hold. (This action deletes the job
from the print queue.) Reissue your command, and then remove the hold; the job will
enter the device queue again and print completely.
Cause. The OWNER command has an incorrect group-name.user-name. Either
the group-name or the user-name does not exist on this system, or you put a space
between the group-name and the user-name.
Effect. The spooler does not execute your command.
Recovery. Reenter your command with the correct group-name.user-name. Place
a period between group-name and user-name, and leave no spaces on either side
of the period.
THE JOB IS CURRENTLY BEING PRINTED
USERNAME NOT FOUND