Spooler Plus Utilities Reference Manual

Spoolcom Messages
Spooler Plus Utilities Reference Manual—522294-002
C-4
Cause. A process name was specified that has incorrect syntax.
Effect. Spoolcom ignores the command.
Recovery. Correct the syntax, and then reexecute the command.
Cause. A Spoolcom command has an illegal subcommand after the comma.
Effect. Spoolcom executes the command but not the subcommand portion.
Recovery. Either use the correct subcommand for this command, or enter a command
that uses the subcommand you want.
Cause. A Spoolcom command was entered with a subcommand parameter that has
an illegal value or incorrect syntax.
Effect. Spoolcom ignores the command.
Recovery. Check the syntax of the subcommand for characters that are not letters,
digits, or spaces. Then reenter the command.
Cause. You attempted to link a job to a batch job to which it already belongs.
Effect. The operation is ignored.
Recovery. This is informational only; no corrective action is needed.
Cause. An attempt was made to delete a job that was either currently printing or still
spooling (in the OPEN state).
Effect. Spoolcom ignores your command.
Recovery. Put the job on hold. If it was printing, you can delete it right away. If it is an
open job, you can delete it after it finishes spooling.
INVALID PROCESS NAME
INVALID SUBCOMMAND
INVALID SUBCOMMAND PARAMETER
JOB ALREADY IS PART OF A BATCH JOB
JOB number IN USE