Spooler Plus Utilities Reference Manual

Spoolcom Messages
Spooler Plus Utilities Reference Manual—522294-002
C-5
Cause. A JOB command was entered that cannot be executed while your job is in its
present state.
Effect. Spoolcom ignores the command.
Recovery. Refer to Section 3, Spoolcom for a list of the valid job states for the JOB
command. Determine the correct state required for the requested operation. Then put
the job into the correct state and reexecute the command.
Cause. You attempted to unlink a job from a batch job, but they were not linked.
Effect. The operation is ignored.
Recovery. This message is informational only; no corrective action is needed.
Cause. More than one subcommand was entered for a JOB command with qualifiers,
and an earlier subcommand deleted a qualified job.
Before Spoolcom executes a subcommand, it first uses the specified qualifiers to
prepare a list of jobs; it does not recompile a new list of jobs for each subcommand.
As a result, it displays this message for each deleted job when it cannot perform a later
subcommand on it.
Effect. Spoolcom does not execute the subsequent subcommand or anything
following it.
Recovery. This message is informational only; no corrective action is needed.
Cause. A Spoolcom JOB command was entered that would affect jobs other than your
own. Such commands are restricted to authorized users such as system operators
(user ID 255,n) and group managers (user ID n,255).
Effect. Spoolcom ignores the command.
Recovery. Informational message only; no corrective action is needed.
JOB number INVALID OPERATION IN CURRENT STATE
JOB IS NOT PART OF A BATCH JOB
JOB number NOT FOUND
JOB number SECURITY VIOLATION