Spooler Plus Utilities Reference Manual

Spoolcom Messages
Spooler Plus Utilities Reference Manual—522294-002
C-8
Cause. A Guardian file-system error occurred when the application attempted to open
a file to the supervisor.
Effect. The spooler has no supervisor at this time. Spoolcom ignores the command to
open a file, and the file to a previous supervisor (if any) is closed.
Recovery. Refer to the Guardian Procedure Errors and Messages Manual for
corrective action for file-system error number.
Remove the error condition before you try to open a file to the supervisor again.
If file-system error 14 occurred, you must bring up the supervisor before the operation
can succeed.
If file-system error 32 or 34 occurred, the supervisor has too many opens at one time.
Wait until some operations have finished and then retry the operation.
Cause. A command to add an entry was issued, but the maximum number of devices,
locations, or processes specified when the spooler was coldstarted was already
reached.
Effect. Spoolcom ignores the command.
Recovery. Drain the spooler, and then add more of the needed components before
warm starting.
Cause. A command was issued to list the open jobs for a collector that has no jobs
currently open.
Effect. The operation is ignored.
Recovery. Informational message only; no corrective action is needed.
Cause. Either the user ID was not recognized on the system or network or
$SYSTEM.SYSTEM.USERID cannot be accessed.
Effect. Spoolcom executes the command.
Recovery. Specify a valid user ID.
SPOOLER OPEN ERROR number
TABLE LIMIT EXCEEDED
THERE ARE NO JOBS CURRENTLY OPEN
WARNING: USERID NOT DEFINED