Spooler Plus Utilities Reference Manual

Font Utility Messages

Spooler Plus Utilities Reference Manual—522294-002

D-6

Cause. An internal Font utility error occurred. Error nnnnnn was returned from a

SPOOLWRITE procedure call. The Font utility was attempting to send Font job data to

the collector that was receiving a new Font job.

Effect. The Font utility aborts. Any Font jobs created and configuration changes made

to this point remain.

Recovery. Contact your service representative. In most cases, you can fix the script

file and rerun the Font utility without undoing any configuration changes that the Font

utility made in the spooler.

There might be a job that was created in the spooler that has its ABNORMAL flag set

to YES because the Font utility did not close the job properly. This job should be

deleted. You can find jobs that the Font utility created with the following Spoolcom

command:

SPOOLCOM ; JOB (REPORT LASER FONT JOB)

If the job has an X in the FLAGS column and the TIME field corresponds to the time

that you ran the Font utility, delete this job.

Cause. The number specified after the H character is invalid. It is greater than HFF, or

less than 0, or does not consist of the hexadecimal digits 0 through F. It must be a

hexadecimal number in the range H0 through HFF.

Effect. The Font utility aborts. Any Font jobs created and configuration changes made

to this point remain.

Recovery. Correct the byte value specified after the H character. In most cases, you

can fix the script file and rerun the Font utility without undoing any configuration

changes that the Font utility made in the spooler.