Spooler Plus Utilities Reference Manual

Font Utility Messages
Spooler Plus Utilities Reference Manual—522294-002
D-8
Cause. The param value specified in the CONTROL directive is invalid. param must
be a positive decimal number in the range 0 through 32767.
Effect. The Font utility aborts. Any Font jobs created and configuration changes made
to this point remain.
Recovery. Correct the param value in the CONTROL directive. In most cases, you
can fix the script file and rerun the Font utility without undoing any configuration
changes that the Font utility made in the spooler.
There might be a job that was created in the spooler that has its ABNORMAL flag set
to YES because the Font utility did not close the job properly. This job should be
deleted. You can find jobs that the Font utility created with the following Spoolcom
command:
SPOOLCOM ; JOB (REPORT LASER FONT JOB)
If the job has an X in the FLAGS column and the TIME field corresponds to the time
that you ran the Font utility, delete this job.
Cause. The operation value specified in the CONTROLBUF directive is invalid.
operation must be a number in the range 0 through 32767.
Effect. The Font utility aborts. Any Font jobs created and configuration changes made
to this point remain.
Recovery. Correct the operation value in the CONTROLBUF directive. In most
cases, you can fix the script file and rerun the Font utility without undoing any
configuration changes that the Font utility made in the spooler.
There might be a job that was created in the spooler that has its ABNORMAL flag set
to YES because the Font utility did not close the job properly. This job should be
deleted. You can find jobs that the Font utility created with the following Spoolcom
command:
SPOOLCOM ; JOB (REPORT LASER FONT JOB)
If the job has an X in the FLAGS column and the TIME field corresponds to the time
that you ran the Font utility, delete this job.
^ ** ERROR Invalid CONTROL parameter
^ ** ERROR Invalid CONTROLBUF Operation