Spooler Plus Utilities Reference Manual

Font Utility Messages
Spooler Plus Utilities Reference Manual—522294-002
D-11
Cause. The source-file filename specified in the SOURCE directive is an invalid
file name.
Effect. The Font utility aborts. Any Font jobs created and configuration changes made
to this point remain.
Recovery. Correct source-file in the SOURCE directive. In most cases, you can
fix the script file and rerun the Font utility without undoing any configuration changes
that the Font utility made in the spooler.
There might be a job that was created in the spooler that has its ABNORMAL flag set
to YES because the Font utility did not close the job properly. This job should be
deleted. You can find jobs that the Font utility created with the following Spoolcom
command:
SPOOLCOM ; JOB (REPORT LASER FONT JOB)
If the job has an X in the FLAGS column and the TIME field corresponds to the time
that you ran the Font utility, delete this job.
Cause. The trailing-count specified in the SOURCE directive is invalid.
trailing-count must be a number in the range 0 through 32767.
Effect. The Font utility aborts. Any Font jobs created and configuration changes made
to this point remain.
Recovery. Correct the value for trailing-count in the SOURCE directive. In most
cases, you can fix the script file and rerun the Font utility without undoing any
configuration changes that the Font utility made in the spooler.
There might be a job that was created in the spooler that has its ABNORMAL flag set
to YES because the Font utility did not close the job properly. This job should be
deleted. You can find jobs that the Font utility created with the following Spoolcom
command:
SPOOLCOM ; JOB (REPORT LASER FONT JOB)
If the job has an X in the FLAGS column and the TIME field corresponds to the time
that you ran the Font utility, delete this job.
^ ** ERROR Invalid SOURCE Filename
^ ** ERROR Invalid trailing-count