Spooler Plus Utilities Reference Manual

Peruse
Spooler Plus Utilities Reference Manual—522294-002
2-25
JOB Command
*
specifies the job most recently added to the spooler subsystem. Entering an
asterisk causes the most recently added job to become the current job.
S[TATUS]
returns an expanded display of the status of the current job. See the
description of #location-name.
#location-name
is the name of a spooler location in the form #group.destination. It
specifies the job most recently sent to that location.
For more information on spooler locations, refer to the Guardian User's Guide.
If you do not specify an option, then the status of all jobs that you own is displayed.
Considerations
•
If you are a group manager (user ID n,255), the JOB command displays the status
of all jobs that belong to your group members if manager access is enabled for the
spooler (through the Spoolcom SPOOLER, MGRACCESS command). Assuming
manager access is enabled for the spooler, you can enable and disable the display
of your group’s jobs by using the SHOWGROUP command as described later in
this section.
•
If you are a system operator (user ID 255,n), the JOB command displays the status
of all jobs in the spooler.
•
The JOB command with the STATUS option produces a display such as the
following for the current job:
•
The first part is similar to the normal JOB command display described under
Running Peruse, earlier in this section.
JOB BATCH STATE PAGES COPIES PRI HOLD LOCATION REPORT
J 310 READY 2 1 4 #HOLD MANUALS JIM
JOB FORM CLOSE TIME
310 14 JUL 97,13:52:05
JOB LOCATION DEVICE SEQ COPY PAGE
310 #HOLD.DEFAULT
$HT10.#HT10 72 1 1