Spooler Plus Utilities Reference Manual

Peruse
Spooler Plus Utilities Reference Manual—522294-002
2-33
NUMCOL Command
Example
In this example, you have specified #HOLD as list-file in order to examine the job
before printing:
Once you finish inspection, use the LOC command to redirect the output to the
specified printer for a hard copy:
NUMCOL Command
The NUMCOL command alters the number of columns displayed when a job is listed.
number-of-columns
is the number of columns, counting from the left margin, that are to be displayed or
printed.
Considerations
•
When Peruse is first run, the value for NUMCOL is 0 and the width of the printing
device determines the number of columns to be printed. If NUMCOL is set to a
value other than 0, the value specified is used as the output width. An even value
is recommended. NUMCOL cannot be set to a value less than zero.
•
NUMCOL can be used with STARTCOL to list only a few columns of a job.
_JOB
JOB BATCH STATE PAGES COPIES PRI HOLD LOCATION REPORT
J 777 READY 22 1 4 #HOLD ACCOUNT ED
_
_LOC #LP3;J
JOB BATCH STATE PAGES COPIES PRI HOLD LOCATION REPORT
J 777 READY 22 1 4 #LP3 ACCOUNT ED
_
NUMCOL number-of-columns