Spooler Programmer's Guide

Spooler-Related Errors
Spooler Programmer’s Guide—522287-002
C-6
Spooler Utility Errors
Recovery. Load more paper, close the bail, or replace the ribbon as needed.
Cause. A modem error occurred. For example, the communications link is not yet
established, a modem failure occurred, a momentary loss of carrier occurred, the
modem or link is disconnected, the interprocessor bus monitor process ($IPB) reported
that the FOX link to an Expand line-handler process is down, or a subunit or logical unit
is not in the started condition.
Effect. The procedure sets the error code and returns without performing the
requested operation.
Recovery. Corrective action is device-dependent. If the problem is still not apparent,
submit the trace, OPRLOG, CONFLIST, and subunit and line configuration to your HP
representative.
Cause. A processor probably failed.
Effect. The collector is opened with a sync depth of 0, and its backup process takes
over.
Recovery. You can retry a write, but lines of data might be lost.
Spooler Utility Errors
The spooler utility procedures return the following error codes:
Cause. The operation completed successfully.
Effect. None.
Recovery. None.
Cause. A parameter is missing.
Effect. The spooler ignores your request.
140 (%214) MODEM ERROR (COMMUNICATION LINK NOT YET
ESTABLISHED, MODEM FAILURE, MOMENTARY
LOSS OF CARRIER, OR DISCONNECT)
201 (%311) CURRENT PATH TO DEVICE IS DOWN ATTEMPT WAS
MADE TO WRITE TO A NONEXISTENT PROCESS, OR
ERROR IN MESSAGE SYSTEM INTERFACE
0 (%0)
4096 (%10000)