Spooler Programmer's Guide

Spooler-Related Errors
Spooler Programmer’s Guide—522287-002
C-15
Print Procedure Errors
If the error occurs after you have stopped and restarted the print process, shut down
the spooler and then warmstart it.
Cause. The print process received a request from the supervisor to perform an action
on a device that is busy.
Effect. The spooler takes the device in question offline. If the error occurs before the
job has finished printing, the job remains in the spooler print queue. If the job has
finished printing but the device has not been closed, the job is deleted from the print
queue.
Recovery. Using Spoolcom, restart the device (for example, issue the DEV
$LP, START command).
If the error persists, stop and then restart the print process.
If the error occurs after you have stopped and restarted the print process, shut down
the spooler and then warmstart it.
Cause. The print process received a request from the supervisor to start a job, but the
print process has run out of device table space.
Effect. The spooler takes the device in question offline. If the error occurs before the
job has finished printing, the job remains in the spooler print queue. If the job has
finished printing but the device has not been closed, the job is deleted from the print
queue.
Recovery. Using Spoolcom, restart the device (for example, issue the DEV
$LP, START command).
If the error persists, stop and then restart the print process.
If the error occurs after you have stopped and restarted the print process, shut down
the spooler and then warmstart it.
5635 (%13003)
5636 (%13004)