Spooler Utilities Reference Manual

Spoolcom
Spooler Utilities Reference Manual—522295-003
4-16
COLLECT Command
COLLECT STATUS Display
The STATUS subcommand can be issued at any time. It produces a display with the
following headings:
COLLECT STATE FLAGS CPU PRI UNIT DATA FILE %FULL
Table 4-4 describes the COLLECT STATUS display entries.
Examples for All Users
1. To show the status of all collectors on the system, enter
The following information is displayed:
Table 4-4. COLLECT STATUS Display Entries
Entry Description
COLLECT Is the collector name.
STATE Is the state of the collector. STATE can be one the following:
ACTIVE The collector process is running. This means that it
is either collecting data or waiting to collect data.
DORMANT The collector process is not running.
DRAIN The collector process has stopped accepting new
jobs and will enter the dormant state when all open
jobs have finished spooling.
ERROR %nnn The collector process has failed. It must be
removed from this state before it can become active
again. When the collector is in the error state, the
octal number that follows ERROR indicates the error
condition. It can be either %1000 plus a file-system
error number or %100000 plus a NEWPROCESS
error number.
FLAGS
Shows a D if the collector is in debug mode.
CPU
Gives the numbers of the processors running the primary and backup
processes when the collector was started.
PRI
Is the execution priority of the collector.
)COLLECT, STATUS
COLLECT STATE FLAGS CPU PRI UNIT DATA FILE %FULL
$C ACTIVE 3 ,10 146 16 $ACC.SPOOLER.DATA 0
$G ACTIVE 4 , 5 146 8 $PUB.SPOOLER.DATA 5
)