Spooler Utilities Reference Manual

Spoolcom
Spooler Utilities Reference Manual—522295-003
4-56
JOB Command
The following information is displayed:
4. In the following example, the JOB command is used to alter job attributes. The job
is placed in the hold state to make the changes, the hold-after-printing flag (A) is
set on, the report name for the header page is altered, and a status display is again
requested, followed by the START subcommand to remove the job from the hold
state:
The following information is displayed:
5. Placing a job in the hold state truncates the display, as shown above. You must
specify the STATUS subcommand after removing the hold in order to see the two-
line display:
JOB: 3000
STATE: READY
LOCATION: #LOC1
FORM:
REPORT: COMMSW RJ
HOLD BEFORE PRINT: NO
HOLD AFTER PRINT: NO
ABNORMAL: NO
SELECTION PRIORITY: 4
PAGE SIZE: 60
CREATOR ACCESS ID: 4, 19
COPIES: 1
PAGES: 3
TOTAL LINES: 169
OPEN TIME: 28 MAY 96, 10:23:00
CLOSE TIME: 28 MAY 96, 10:23:18
DATA FILE: $KIRK.TESTLIM.CD1
COLLECTED BY: $COL1
UNITS ALLOCATED: 2
BATCH ID:
BATCH NAME:
MAXIMUM LINES:
MAXIMUM PAGES:
)JOB 36, HOLD, HOLDAFTER, REPORT PB REPT,STATUS,START
JOB BATCH STA FLAGS OWNER TIME COPY PAGE REPORT LOCATION
36 HLD 4 A 4,19 10:18 1 5 PB REPT #UNTIL
JOB BATCH STA FLAGS OWNER TIME COPY PAGE REPORT LOCATION
36 RDY 4 A 4,19 10:18 1 1 PB REPT #UNTIL
JOB LOCATION DEVICE SEQ COPY PAGE
36 #UNTIL.DEFAULT 1 1 1