Spooler Utilities Reference Manual

Spoolcom
Spooler Utilities Reference Manual—522295-003
4-74
SPOOLER Command
SPOOLER STATUS Display
The STATUS subcommand produces a display with the following headings:
SPOOLER STATE LOGGING FILE LAST ERROR
Table 4-17 describes the SPOOLER STATUS display entries.
Example for All Users
1. Using the SPOOLER command, you can obtain the status of your spooler:
The following information is displayed:
Table 4-17. SPOOLER STATUS Display Entries
Entry Description
SPOOLER Is the process name of the spooler.
STATE Is the state of the spooler (active, drain, warm, or cold).
Spoolcom cannot communicate with a dormant spooler.
Refer to the Spooler Programmer’s Guide for a full
description of the spooler states.
ACTIVE The spooler is fully operational and ready to
accept output from application processes.
DRAIN The collector process has stopped accepting
new jobs and will enter the dormant state after
all open jobs have finished spooling. Once
drained, the spooler enters the dormant state.
WARM This state indicates the restarting of a spooler
that was previously active.
COLD
This state indicates the starting of a new
spooler
.
LOGGING FILE
Is the spooler error log file.
LAST ERROR Is the octal number of the last error sent to the error log
file. Bits 8 through 15 contain the octal file-system error
number. All of the file-system errors are described in the
Guardian Procedure Errors and Messages Manual.
)SPOOLER
SPOOLER STATE LOGGING FILE LAST
ERROR
$SPLS ACTIVE $0