Spooler Utilities Reference Manual

RPSetup Utility
Spooler Utilities Reference Manual—522295-003
6-14
ASSIGN and PARAM Commands
For more information on parameter values, see the DEV PARM command in Section 4,
Spoolcom.
PARAM DEVRESTART
The PARAM DEVRESTART command sets the interval the device waits between
automatic restart attempts. This configuration parameter applies individually to all
interspooler threads. The command is similar to the SPOOLCOM command
DEV RESTART.
interval
is the number of seconds the device waits between automatic restart attempts.
The value is in the range 10 through 32767 seconds. The default is 30 seconds.
PARAM DEVTRUNC
The PARAM DEVTRUNC command specifies whether lines longer than the device
width are to be truncated or wrapped around. This configuration parameter applies
individually to all interspooler threads. The command is equivalent to the SPOOLCOM
command DEV TRUNC.
ON
causes the print process to discard the ends of spooled lines that are longer than
the device width.
OFF
causes the print process to print on the next sequential line the ends of any
spooled lines that are longer than the device width. The default value is OFF.
< 12 > 0 Omits any HOLDAFTER flag for a
job transferred to target spooler
Same as < 11 >.
1 Retains any HOLDAFTER flag for a
job transferred to a target spooler
< 13 > 0 Sets target location name to that of
the source job location
Equals 0. For example, a job sent
to location $S.#OFFICE.A has this
same location name after being
transferred to the target spooler.
1 Sets target location name to that of
the device thread name
PARAM DEVRESTART interval
PARAM DEVTRUNC { ON | OFF }
Table 6-2. Default Attributes Set by FASTP on Interspooler Transferred Print
Jobs (page 2 of 2)
Bit Value Attribute of Transferred Print Jobs FASTP’s Default Operation