Spooler Utilities Reference Manual

Spooler Utilities Reference Manual—522295-003
B-1
B Peruse Messages
This appendix describes the Peruse error messages that are displayed on your
terminal. For additional information on Peruse, see Section 3, Peruse.
Cause. A file-system error occurred during input/output (I/O) to a spooler data file.
Effect. Peruse cannot access the data file for this job.
Recovery. For corrective action of the file-system error number, see the Guardian
Procedure Errors and Messages Manual.
Cause. A file-system error occurred during input/output (I/O) to a supervisor process.
Effect. The operation terminates.
Recovery. Check the status of the supervisor using the Spoolcom SPOOLER
command, or call the system operator. Also, refer to the Guardian Procedure Errors
and Messages Manual for corrective action for the file-system error number.
Cause. The OUT file of a LIST command was a nonexistent disk file. Peruse tried to
create the file and CREATE failed. number specifies the file-system error.
Effect. The operation terminates.
Recovery. For corrective action of the file-system error number, see the Guardian
Procedure Errors and Messages Manual.
Cause. The Guardian OPEN procedure returned an error when Peruse tried to open
the OUT file.
Effect. Peruse does not open the OUT file.
Recovery. For corrective action of the file-system error number, see the Guardian
Procedure Errors and Messages Manual.
ACCESS TO SPOOL DATA FILE FAILED, FILE ERROR number
ACCESS TO SPOOL SUPERVISOR PROCESS FAILED, FILE ERROR number
CAN'T CREATE 'OUT' FILE: number
CAN'T OPEN 'OUT' FILE: number