Spooler Utilities Reference Manual

Peruse Messages
Spooler Utilities Reference Manual—522295-003
B-2
Cause. An exclamation point (!) was specified with the OUT file of a LIST command
and the file could not be purged. number specifies the file-system error number.
Effect. The operation terminates.
Recovery. For corrective action of the file-system error number, see the Guardian
Procedure Errors and Messages Manual.
Cause. SPOOLSTART failed for the OUT file of a LIST command. number specifies
the spooler error number.
Effect. The operation terminates.
Recovery. For corrective action of the file-system error number, see the Guardian
Procedure Errors and Messages Manual.
Cause. The spooler is in the drain or dormant state, and the command required an
operation that conflicted with the spooler state.
Effect. The command is ignored.
Recovery. Warmstart the spooler so that you can set and modify its attributes.
Cause. A command was invoked that is not supported for spooler job files, and a
spooler job file was the current job.
Effect. The command is not executed.
Recovery. If you intended to execute the command against a spooler job, make it the
current job and retry the command.
Cause. The command referred to a job that is no longer in the spooler.
Effect. The spooler ignores the command.
Recovery. Respool your job, and then reexecute your command.
CAN'T PURGE 'OUT' FILE: number
CAN'T SPOOLSTART 'OUT' FILE: number
COMMAND CANNOT BE ACCOMPLISHED GIVEN CURRENT SPOOLER STATE
COMMAND NOT SUPPORTED FOR SPOOLER JOB FILES
CURRENT JOB HAS BEEN DELETED FROM SPOOLER