Spooler Utilities Reference Manual

Peruse Messages
Spooler Utilities Reference Manual—522295-003
B-8
Cause. You attempted an operation on a job that is part of a batch job.
Effect. The operation is ignored.
Recovery. Either retry the operation on the batch job, or unlink the job from the batch
job and then retry the operation.
Cause. A Guardian OPEN procedure encountered a file-system error.
Effect. Peruse cannot open the spooler supervisor process specified in the command
to run Peruse or the Peruse OPEN command. (The spooler supervisor process is
$SPLS or a name given by supervisor.)
Recovery. Verify that you specified the correct spooler supervisor. If you did not,
reexecute your command. If you did, refer to the Guardian Procedure Errors and
Messages Manual for corrective action for the file-system error number.
If the error is file-system error 14, the spooler has no supervisor. Bring the system up
again.
If the error is file-system error 32 or 34, the supervisor has too many opens at one
time. Wait until some operations have finished, and then retry the operation.
Cause. The OUT file specified in the Peruse command is full. number specifies the
file-system error number.
Effect. The Peruse command cannot write in the OUT file.
Recovery. For corrective action of the file-system error number, see the Guardian
Procedure Errors and Messages Manual.
Cause. EDIT was specified in a LIST command, and the OUT file was not an EDIT
file.
Effect. The command is not executed.
Recovery. Specify an EDIT file as the OUT file, and then retry the command.
NOT ALLOWED ON PART OF A BATCH JOB
OPEN OF SPOOL SUPERVISOR FAILED, FILE ERROR: number
'OUT' FILE IS FULL:number
'OUT' FILE MUST BE EDIT FILE