Spooler Utilities Reference Manual

Spooler Utilities Reference Manual—522295-003
D-1
D Font Utility Messages
This appendix describes the error messages that the Font utility displays to the OUT
file of the command used to run Font (the default is the home terminal).
Cause. The number specified after the # character is invalid. It is greater than 255,
less than 0, or does not consist of the digits 0 through 9. It must be a decimal number
in the range 0 through 255.
Effect. The Font utility aborts. Any font jobs created and configuration changes made
to this point remain.
Recovery. Correct the byte value specified after the # character. In most cases, you
can fix the script file and rerun the Font utility without undoing any configuration
changes that the Font utility made in the spooler.
There might be a job that was created in the spooler that has its ABNORMAL flag set
to YES because the Font utility did not close the job properly. This job should be
deleted. You can find jobs that the Font utility created with the following Spoolcom
command:
SPOOLCOM ; JOB (REPORT LASER FONT JOB)
If the job has an X in the FLAGS column and the TIME field corresponds to the time
that you ran the Font utility, delete this job.
Cause. The device name specified is not a valid device name. The device name must
be a valid Guardian file name, process name, or device name in the form:
[\system.][$name1.][[#name2.][name3]
One of these, name1, name2, or name3, must be specified.
Effect. The Font utility aborts. Any font jobs created and configuration changes made
to this point remain.
Recovery. Correct the device name. For syntax descriptions of process or device
names, see the Guardian Procedure Calls Reference Manual.
In most cases, you can fix the script file and rerun the Font utility without undoing any
configuration changes that the Font utility made in the spooler.
^ ** ERROR Decimal Number too big or invalid
^ ** ERROR Device Name invalid