Spooler Utilities Reference Manual

Font Utility Messages
Spooler Utilities Reference Manual—522295-003
D-2
Cause. The font-name parameter specified in the FONT directive or after a location
in the locations section was more than 16 characters long.
Effect. The Font utility aborts. Any font jobs created and configuration changes made
to this point remain.
Recovery. Shorten the font name so that it does not exceed 16 characters. In most
cases, you can fix the script file and rerun the Font utility without undoing any
configuration changes that the Font utility made in the spooler.
Cause. Either the font-name parameter specified in the FONT directive contains
spaces, or a comment after font-name did not begin with an exclamation point (!).
Effect. The Font utility aborts. Any font jobs created and configuration changes made
to this point remain.
Recovery. Either remove blanks from the font name or put the ! character before any
comments on this line. In most cases, you can fix the script file and rerun the Font
utility without undoing any configuration changes that the Font utility made in the
spooler.
Cause. The Font utility received error nnnnnn from a PRINTREAD call when trying to
read the next record from the spooler job file (file code 129) specified as a source file in
a SOURCE directive.
Effect. The Font utility aborts. Any font jobs created and configuration changes made
to this point remain.
Recovery. Contact your service representative. In most cases, you can fix the script
file and rerun the Font utility without undoing any configuration changes that the Font
utility made in the spooler.
There might be a job that was created in the spooler that has its ABNORMAL flag set
to YES because the Font utility did not close the job properly. This job should be
deleted. You can find jobs that the Font utility created with the following SPOOLCOM
command:
SPOOLCOM ; JOB (REPORT LASER FONT JOB)
If the job has an X in the FLAGS column and the TIME field corresponds to the time
that you ran the Font utility, delete this job.
^ ** ERROR FONT name greater than 16 chars
^ ** ERROR FONT name must be contiguous
^ ** ERROR %nnnnnn from PRINTREAD