Spooler Utilities Reference Manual

Font Utility Messages
Spooler Utilities Reference Manual—522295-003
D-10
Cause. The function value specified in the SETMODE directive is invalid. The
value must be a number in the range 0 through 32767.
Effect. The Font utility aborts. Any font jobs created and configuration changes made
to this point remain.
Recovery. Correct the function value in the SETMODE directive. In most cases,
you can fix the script file and rerun the Font utility without undoing any configuration
changes that the Font utility made in the spooler.
There might be a job that was created in the spooler that has its ABNORMAL flag set
to YES because the Font utility did not close the job properly. This job should be
deleted. You can find jobs that the Font utility created with the following SPOOLCOM
command:
SPOOLCOM ; JOB (REPORT LASER FONT JOB)
If the job has an X in the FLAGS column and the TIME field corresponds to the time
that you ran the Font utility, delete this job.
Cause. The param1 or param2 value specified in the SETMODE directive is invalid.
param1 or param2 must be a number in the range 0 through 32767.
Effect. The Font utility aborts. Any font jobs created and configuration changes made
to this point remain.
Recovery. Correct the values for param1 and param2 in the SETMODE directive. In
most cases, you can fix the script file and rerun the Font utility without undoing any
configuration changes that the Font utility made in the spooler.
There might be a job that was created in the spooler that has its ABNORMAL flag set
to YES because the Font utility did not close the job properly. This job should be
deleted. You can find jobs that the Font utility created with the following SPOOLCOM
command:
SPOOLCOM ; JOB (REPORT LASER FONT JOB)
If the job has an X in the FLAGS column and the TIME field corresponds to the time
that you ran the Font utility, delete this job.
^ ** ERROR Invalid SETMODE Operation
^ ** ERROR Invalid SETMODE parameter