Spooler Utilities Reference Manual

Font Utility Messages
Spooler Utilities Reference Manual—522295-003
D-12
Cause. The operation value was not found in a CONTROL directive in a font
description.
Effect. The Font utility aborts. Any font jobs created and configuration changes made
to this point remain.
Recovery. Specify an operation value in the CONTROL directive. In most cases,
you can fix the script file and rerun the Font utility without undoing any configuration
changes that the Font utility made in the spooler.
There might be a job that was created in the spooler that has its ABNORMAL flag set
to YES because the Font utility did not close the job properly. This job should be
deleted. You can find jobs that the Font utility created with the following SPOOLCOM
command:
SPOOLCOM ; JOB (REPORT LASER FONT JOB)
If the job has an X in the FLAGS column and the TIME field corresponds to the time
that you ran the Font utility, delete this job.
Cause. The param value was not found in a CONTROL directive in a font description.
Effect. The Font utility aborts. Any font jobs created and configuration changes made
to this point remain.
Recovery. Specify a param value in the CONTROL directive. In most cases, you can
fix the script file and rerun the Font utility without undoing any configuration changes
that the Font utility made in the spooler.
There might be a job that was created in the spooler that has its ABNORMAL flag set
to YES because the Font utility did not close the job properly. This job should be
deleted. You can find jobs that the Font utility created with the following SPOOLCOM
command:
SPOOLCOM ; JOB (REPORT LASER FONT JOB)
If the job has an X in the FLAGS column and the TIME field corresponds to the time
that you ran the Font utility, delete this job.
^ ** ERROR Missing CONTROL Operation
^ ** ERROR Missing CONTROL Parameter