Spooler Utilities Reference Manual

Font Utility Messages
Spooler Utilities Reference Manual—522295-003
D-17
Cause. The Font utility could not open the source file (file-name) specified in the
SOURCE directive.
Effect. The Font utility aborts. Any font jobs created and configuration changes made
to this point remain.
Recovery. Refer to the Guardian Procedure Errors and Messages Manual for
corrective action for file-system error nnnn. In most cases, you can fix the script file
and rerun the Font utility without undoing any configuration changes that the Font utility
made in the spooler.
There might be a job that was created in the spooler that has its ABNORMAL flag set
to YES because the Font utility did not close the job properly. This job should be
deleted. You can find jobs that the Font utility created with the following SPOOLCOM
command:
SPOOLCOM ; JOB (REPORT LASER FONT JOB)
If the job has an X in the FLAGS column and the TIME field corresponds to the time
that you ran the Font utility, delete this job.
Cause. The Font utility could not read the source-file (file-name) specified in the
SOURCE directive.
Effect. The Font utility aborts. Any font jobs created and configuration changes made
to this point remain.
Recovery. Refer to the Guardian Procedure Errors and Messages Manual for
corrective action for file-system error nnnn. In most cases, you can fix the script file
and rerun the Font utility without undoing any configuration changes that the Font utility
made in the spooler.
There might be a job that was created in the spooler that has its ABNORMAL flag set
to YES because the Font utility did not close the job properly. This job should be
deleted. You can find jobs that the Font utility created with the following SPOOLCOM
command:
SPOOLCOM ; JOB (REPORT LASER FONT JOB)
If the job has an X in the FLAGS column and the TIME field corresponds to the time
that you ran the Font utility, delete this job.
^ ** ERROR ( OPEN^FILE ) nnnn on file-name
^ ** ERROR ( READ^FILE ) nnnn on file-name