Spooler Utilities Reference Manual

Font Utility Messages
Spooler Utilities Reference Manual—522295-003
D-21
Effect. The Font utility aborts.
Recovery. Specify an existing supervisor process.
Cause. The Font utility received an error from the SPOOLERSTATUS procedure.
command-name is a text description of the command. subcommand-name is a text
description of the subcommand. sss is the SCAN^TYPE value passed to
SPOOLERSTATUS.
Either the spooler does not have a collector process configured or none of the collector
processes is in the active state.
Effect. The Font utility aborts.
Recovery. Either configure a collector in the spooler or change the collector status to
active to allow the Font utility to spool a font job.
Cause. The locations section (following a START-LOCATIONS directive) specified a
device name that does not exist.
Effect. The Font utility uses the first device it finds in the spooler. If there are no
devices defined in the spooler, the location that is created is not linked to a device.
Recovery. Specify an existing spooler device name.
**SPOOLERSTATUS Error :%14006 ( End of Spoolerstatus hits )
**Cmd: ( "command-name" , "subcommand-name") Scan: sss
** WARNING ** Can't find Device: device to add to
Location: location